en Installation and connection
36
Align refrigerator compartment doors
Align the vertical gap of the doors:
Note: Remove the contents of the doors, if present.
1. Remove the screw T20 and cap on the door hinge.
2. Loosen the safety screw.
Caution!
Do not remove the safety screw.
3. With the door closed, turn the adjustment screw until
the desired position is reached.
– To move the upper end of the door outwards, turn
clockwise.
– To move the upper end of the door inwards, turn
anticlockwise.
4. To check the position, close the door and correct if
necessary.
5. Tighten the safety screw again.
6. Fit the cap and screw in the screw T20 again.
To Next Page
Loading...
