Siemens KF96NAXEA - Setting up Home Connect

HomeConnect en
19
To be able to use HomeConnect,
you must first set up the connection
to the WLAN home network (Wi-Fi
1
)
and to the HomeConnect app.
After switching on the appliance, wait
at least 2minutes until internal
device initialisation is complete. Only
then should you set up HomeCon-
nect.
The HomeConnect app guides you
through the entire login process. Fol-
low the instructions in the HomeCon-
nect app to configure the settings.
Tips
¡ Please consult the documents sup-
plied by HomeConnect.
¡ Please also follow the instructions
in the HomeConnect app.
Notes
¡ Please note the safety precautions
in this instruction manual and
make sure that they are also ob-
served when operating the appli-
ance via the HomeConnect app.
→"Safety", Page4
¡ Operating the appliance on the ap-
pliance itself always takes priority.
During this time it is not possible
to operate the appliance using the
HomeConnect app.
10.1 Setting up HomeCon-
nect
Requirement:The HomeCon-
nectapp has been installed on your
mobile device.
1. Scan the QR code using the
HomeConnectapp.
2. Follow the instructions in the
HomeConnectapp.
10.2 Checking the signal
strength
You should check the signal strength
if no connection could be estab-
lished.
1. Press and hold for
15seconds.
a The temperature display (freezer
compartment) shows .
2. Press repeatedly until the
temperature display (freezer com-
partment) shows .
a The temperature display (refriger-
ator compartment) shows a value
between (no reception) and (full
reception).
Note:The signal strength should be
at least .
Improving the reception
If the signal strength is too weak, the
connection may be interrupted.
▶
Carry out one of the solution op-
tions:
‒ Place the router and refrigerator
closer together.
1
Wi-Fi is a registered trademark of the Wi-Fi Alliance.