Siemens KF96NAXEA - Installing Updates for the Home Connect Software; Resetting Home Connect Settings; Remote Diagnostics

en HomeConnect
20
‒ Ensure that the connection is
not interfered with by screening
walls.
‒ Install a repeater to strengthen
the signal.
10.3 Installing updates for the
Home Connect software
The appliance searches for updates
to the HomeConnect software at reg-
ular intervals.
Note:If updates are available, the
temperature display (freezer compart-
ment) shows .
To cancel the update and reset the
temperature display (freezer compart-
ment) to the set temperature, press
any touch field.
1. Press and hold for
15seconds.
a The temperature display (freezer
compartment) shows .
2. Press repeatedly until the
temperature display (freezer com-
partment) shows and the tem-
perature display(refrigerator com-
partment) shows .
3. Press .
a The temperature display (refriger-
ator compartment) shows an anim-
ation.
a The update is installed.
a The control panel is locked during
the installation.
a If the installation is successful, the
temperature display (refrigerator
compartment) shows .
4. If the temperature indicator (refri-
gerator compartment) shows ,
the appliance was unable to install
the update.
‒ Repeat the process at a later
point.
5. If the update cannot be completed
after several attempts, contact cus-
tomer service →Page31 .
10.4 Resetting HomeConnect
settings
If your appliance experiences con-
nection problems with the WLAN
home network (Wi-Fi) or your appli-
ance wants to log into a different
WLAN home network (Wi-Fi), you can
reset the HomeConnectsettings.
1. Press and hold for
15seconds.
a The temperature display (freezer
compartment) shows .
2. Press repeatedly until the
temperature display (freezer com-
partment) shows and the tem-
perature display(refrigerator com-
partment) shows .
3. Press .
a The temperature display (refriger-
ator compartment) shows an anim-
ation for approximately 15
seconds.
a The temperature display (refriger-
ator compartment) shows .
a The HomeConnect settings have
been reset.
10.5 Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the HomeCon-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip:For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
your local website: www.home-con-
nect.com