en
19
Appliance self-test
Your appliance features an automatic
self-test program which shows you
sources of faults which may be repaired
by customer service only.
Starting the appliance self-test
1. Switch off the appliance and wait
5minutes.
2. Switch on appliance and hold down
the super button, Fig. /2, for 3–
5 seconds within the first 10 seconds
until an acoustic signal sounds.
The self-test programme starts.
If an acoustic signal sounds twice, your
appliance is in working order.
If the super button flashes for
10 seconds and an acoustic signal
sounds for 5 seconds, there is a fault.
Inform customer service.
Ending the appliance self-test
When the programme has ended, the
appliance switches over to normal
operation.
Fault Possible cause Remedial action
Freezer compartment
temperature display
flashes. Fig. /4
Warning signal sounds
The Alarm button is lit.
Fig. /5
The freezer
compartment is too
warm!
The frozen food
is at risk of thawing!
To switch off the warning signal,
press the Alarm button 5.
Appliance is open. Close the appliance.
Ventilation openings
have been covered.
Ensure that there is adequate
ventilation.
Too much food was
placed in the freezer
compartment at once.
Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the Alarm display goes out shortly
afterwards.
Freezer compartment
temperature display
flashes. Fig. /4
Afault caused
the freezer
compartment
to become too warm
in the past.
When the alarm button 5 is pressed,
the temperature display stops
flashing. Fig. /4
The temperature display indicates
for 5 seconds the warmest
temperature which was reached
in the freezer compartment.
Appliance is not
cooling, temperature
display and light
are lit.
Showroom mode is
switched on.
Hold down alarm button /5 for
10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
To Next Page
Loading...
