en
8
Switching on
the appliance
1. Switch on the appliance with the On/
Off button. Fig. /1
A warning signal sounds,
the temperature display 4 flashes
and the alarm button 5 is lit.
2. The warning signal is switched off
by pressing the alarm button 5.
The appliance begins to cool. Light is
switched on when the door is open.
Operating tips
■ When the appliance has been
switched on, it may take several hours
until the set temperatures have been
reached.
Do not put any food in the appliance
beforehand.
■ Thesidesofthehousing
are sometimes heated slightly. This
prevents condensation
in the area of the door seal.
■ If you cannot open the freezer
compartment door immediately after
closing it, wait 2–3 minutes until
the partial vacuum has equalised.
Setting
the temperature
Fig.
Refrigerator compartment
The temperature can be set from +2 °C
to +8 °C.
Keep pressing temperature selection
button 7 until the required refrigerator
compartment temperature is set. The
value last selected is stored.
The set temperature is indicated on
display 8.
We recommend a factory setting
of +4 °C in the refrigerator compartment.
Perishable food should not be stored
above +4 °C.
Freezer compartment
The temperature can be set from -16 °C
to -24 °C.
Keep pressing temperature selection
buttons 3 until the required freezer
compartment temperature is set.
The value last selected is stored.
The set temperature
is indicated on display 4.
We recommend a factory setting of
-18 °C in the freezer compartment.
8 Temperature display refrigerator
compartment
The numbers correspond
to the set refrigerator
compartment temperatures in °C.
9 “Super” button (refrigerator
compartment)
Switches super cooling
on and off.
To Next Page
Loading...
Need help?
General
