Siemens KG56FSB40 - Page 16

en
16
Verify signal strength
You should verify the signal strength if no
connection can be established.
1. Press the super cooling button and
the lock/alarm off button
simultaneously to open the Home
Connect menu.
The display shows Cn.
Note
Press both buttons at exactly the
same time. Button operation is locked
if only the lock/alarm off button is
pressed for a longer period. Press the
lock/alarm off button again until the
lock is deactivated.
2. Press the compartment button
repeatedly until the display shows SI.
In the second display, a value appears
between 0 (no reception and 3 (full
reception).
Note
The signal strength should be at least
2. If the signal strength is too low, the
connection could be interrupted. Place
the router and the refrigerator closer
together, ensure that the connection is
not disturbed by shielding walls or
install a repeater to strengthen the
signal.
Resetting Home Connect settings
If the connection process does not work
or you would like to log the refrigerator
on to a different home network (WLAN),
you can reset the Home Connect
settings:
1. Press the super cooling button and
the lock/alarm off button
simultaneously to open the Home
Connect menu.
The display shows Cn.
Note
Press both buttons at exactly the
same time. Button operation is locked
if only the lock/alarm off button is
pressed for a longer period. Press the
lock/alarm off button again until the
lock is deactivated.
2. Press the compartment button
repeatedly until the displays rE and oF
are shown.
3. Press the + button.
■ The display shows a short
animation and then again oF.
The Home Connect settings have
been reset.
■ If the display shows Er, start the
reset again or call customer
service.