en
27
Appliance self-test
Your appliance features an automatic
self-test program which shows you
sources of faults which may be repaired
by customer service only.
Starting the appliance self-test
1. Switch off the appliance and wait 5
minutes.
2. Switch on the appliance and within the
first 10 seconds, press and hold the
compartment button and the "–"
setting button for 3–5 seconds until an
audible signal sounds.
The self-test programme starts.
When the self-test ends and an audible
signal sounds twice, your appliance is
in working order.
If 5 audible signals sound, there is an
error. Inform customer service.
Ending the appliance self-test
When the programme has ended, the
appliance switches over to normal
operation.
Customer service
Your local customer service can be
found in the telephone directory or in
the customer-service index. Please
provide customer service with the
appliance product number (E-Nr.) and
production number (FD-Nr.).
This information can be found on the
rating plate. Fig. ,
To prevent unnecessary call-outs, please
assist customer service by quoting
the product and production numbers.
This will save you additional costs.
Repair order and advice
on faults
Contact information for all countries can
be found on the enclosed customer
service list.
Fault Possible cause Remedial action
Appliance is not cooling,
temperature display and light
are lit.
Showroom mode is switched
on.
Press and hold the compartment button and
the setting button A for 5 seconds until a
confirmation tone sounds.
After a short time, check whether your
appliance is cooling.
The side panels of the
appliance are warm.
Pipes run into the side panels
which heat during the
cooling process.
That is normal behaviour for the appliance and
not a fault.
GB 0344 892 8999 Calls charged at
local or mobile rate.
IE 01450 2655 0.03 € per minute
at peak. Off peak
0.0088 € per
minute.
US 866 447 4363 toll-free
To Next Page
Loading...
