EasyManua.ls Logo

Siemens KI81FHDD0 - Additional Functions; Super Cooling; Alarm; Door Alarm

Siemens KI81FHDD0
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en Additional functions
16
Setting the cool-fresh
compartment temperature
Note:The standard setting of the
cool-fresh compartment is preset at
0. Setting 0 corresponds to a temper-
ature of around 0°C. You can set
the temperature in the cool-fresh
compartment to 3settings warmer or
colder.
Tip:If frost forms on the food items
in the cool-fresh compartment, set a
higher cool-fresh compartment tem-
perature.
1. Press and hold until the tem-
perature display flashes.
2. Press / to change the setting.
Setting –3 corresponds to the
coldest setting.
Setting +3 corresponds to the
warmest setting.
a The selected setting is saved after
one minute.
8 Additional functions
8.1 Super cooling
With Super cooling, the refrigerator
compartment cools as cold as pos-
sible.
Switch on Super cooling before pla-
cing large quantities of food.
Note:When Super cooling is
switched on, increased noise may
occur.
Switching on Super cooling
Press .
a lights up.
Note:After approx. 15hours, the ap-
pliance switches to normal operation.
Switching off Super cooling
Press .
a The previously set temperature is
displayed.
9 Alarm
9.1 Door alarm
If the appliance door is open for a
while, the door alarm switches on.
A warning tone sounds.
Switching off the door alarm
Close the appliance door or press
.
a The warning tone is switched off.
HomeConnect
10 HomeConnect
HomeConnect
This appliance is network-capable.
Connect your appliance to a mobile
device to control its functions via the
HomeConnect app.
The HomeConnect services are not
available in every country. The avail-
ability of the HomeConnect function
depends on the availability of
HomeConnect services in your coun-
try. You can find information about
this at: www.home-connect.com.
To be able to use HomeConnect,
you must first set up the connection
to the WLAN home network (Wi-Fi
1
)
and to the HomeConnect app.
After switching on the appliance, wait
at least 2minutes until internal
device initialisation is complete. Only
then should you set up HomeCon-
nect.
1
Wi-Fi is a registered trademark of the Wi-Fi Alliance.

Table of Contents

Related product manuals