6
Operation
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Setting the fan
Note: Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on
1. Press the # button.
The fan starts at fan setting
ƒ.
2. Move your finger over the ||| settings range to set a different
fan setting.
Switching off the appliance
Press the
# button.
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Switching on
1. Move your finger to the right over the ||| settings range until
the intensive mode
‚2 is shown in the display panel.
The intensive mode
‚2 is activated.
2. Move your finger to the right over the ||| settings range until
the intensive mode
ƒ2 is shown in the display panel.
The intensive mode
ƒ2 is activated.
Note: The run time of the intensive mode is
approx. six minutes. Once this time has elapsed, the appliance
switches back to a lower fan setting.
Switching off
Move your finger to the left over the ||| settings range until you
set the required fan setting.
The intensive mode ends.
Boost function
The boost function is a short-term maximum power setting
which can be activated in any fan setting.
Press the
& button.
After approx. 20 seconds, the fan switches back to the
previously set fan setting.
Automatic mode
Switching on
1. Press the # button.
The fan starts at fan setting
ƒ.
2. Press the ! button.
The optimum fan setting
‚, ƒ or „ is set automatically using
a sensor.
Switching off
Press the
! or # button.
Automatic mode is switched off.
The fan switches off automatically if the air quality in the room
falls below a certain level. Automatic mode can run for a
maximum of four hours.
Sensor control
In automatic mode, a sensor in the extractor hood detects the
intensity of the cooking and roasting odours. Depending on the
sensor setting, the fan automatically switches to another fan
setting.
Default sensitivity setting:
„
Lowest sensitivity setting: ‚
Highest sensitivity setting: †
Changing the sensitivity of the sensor
If the sensor control reacts too quickly or too slowly, change
the sensitivity setting.
1. When the fan is switched off, press and hold the ! button
for approx. four seconds.
The setting is displayed.
2. Move your finger to the left or right over the ||| settings
range to change the sensitivity setting.
3. Press and hold the ! button for approx. four seconds.
The change is saved.
Lighting
The lighting can be switched on and off independently of the
ventilation system.
Switching on or off
Press the
= button.
Setting the brightness
Press and hold the
= button until the required brightness is
reached.
LQW
DXWR
Explanation
#
Switches the fan on/off
=
Switches on the lighting
&
Switches on the Boost function (short-term maximum
power)
!
Switches on automatic mode with fan run-on
-|||+ Sets the fan level
To Next Page
Loading...
Need help?
General
