en Installation instructions
20
9.
Align the rails to the bottom and attach to the
side .
10.
Screw the rails onto the bottom of the unit.
11.
Note:If an appliance with the dimension 90cm is
installed in a unit with a width of 90 cm, skip the
next two installation steps and follow the instructions
in the additional accessory pack.
Screw in the screw from below and tighten the nut.
12.
Align the appliance to the hob and tension it
against the worktop .
13.
Insert the drip tray and snap it into place.
14.
Plug the cables into the fan box.
15.
Insert the glass panel as far as it will go into the
guides.
16.
Connect the appliance to the power supply.
a The glass panel moves downwards and the appli-
ance closes.
17.
Insert the grease filters.
→"Fitting the grease filters", Page11
To Next Page
Loading...
