Siemens LD98WMM60 - Familiarising Yourself with Your Appliance; Before Using for the First Time; Basic Operation; Home Connect

en Familiarising yourself with your appliance
6
5 Familiarising yourself with your appliance
5.1 Controls
You can use the control panel to configure all functions
of your appliance and to obtain information about the
operating status.
5
3
4
1
2
7
6
1
Fan setting 1
2
Fan setting 2
3
Fan setting 3
4
Intensive mode 1
5
Intensive mode 2
6
Odour filter saturation indicator
1
7
Grease filter saturation indicator
1
Depending on the appliance specifications
Switching the appliance on or off
Increasing the fan setting
Decreasing the fan setting
Switching automatic mode
1
on or off
HomeConnect
Reset the filter saturation indicator
Removing or inserting the grease filter/odour
filter
1
Switching Guided Air on or off
1
Depending on the appliance specifications
6 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
6.1 Setting an operating mode
Your appliance is set to air extraction mode by default.
Note:When using it in circulating-air mode, you require
additional accessories.
▶
When using it in circulating-air mode, set the operat-
ing mode.
→"Setting the saturation indicator", Page7
7 Basic operation
7.1 Switching on the appliance
▶
Press to switch on the appliance.
a The appliance starts at fan setting2.
a The Ambient Light
1
automatically switches on.
7.2 Switching off the appliance
▶
Press ⁠.
a The fan run-on starts at fan setting1.
a The Ambient Light
1
remains switched on for ap-
prox.10minutes.
a The glass panel remains extended halfway.
a The appliance switches off automatically after ap-
prox. 10 minutes.
a The glass panel moves downwards and the appli-
ance closes.
7.3 Selecting a fan setting
▶
Press or ⁠.
1
Depending on the appliance specifications