Operating the appliance en
9
Note: When using pans for cooking, use the
appropriate pan lid. If necessary, place the lid on the
pan at a slight angle, with the gap facing the worktop-
mounted ventilation system. This improves the
extraction behaviour of the table ventilation.
Switching on the appliance
Press the
# button.
The extractor hood starts at fan setting 1.
The fan setting that is selected will be shown on the
display panel.
Selecting the fan setting
Press the @ or A button to set the corresponding fan
setting.
The fan setting that is selected will be shown on the
display panel.
Switching off the appliance
Press the # button.
Intensive setting
Activate intensive mode to eliminate strong smells and
odours. In this mode, the extractor hood operates at its
maximum fan setting for a short time. After a short time,
it automatically switches back to a low setting.
Switching on
Press and hold the @ button until › appears on the
display panel.
Intensive mode is now activated.
Note: After 6 minutes, the extractor hood automatically
switches back to the fan setting that was set
beforehand.
Switching off
Press the A button to set a different fan setting.
Run-on function
The run-on function allows the table ventilation to
continue running for a few minutes after it has been
switched off. This eliminates any remaining cooking
smells. The run-on prevents moisture from collecting in
the table ventilation and in the air recirculation in the
cabinet and toe kick. The table ventilation then switches
itself off automatically.
Switching on
Notes
■ If intensive mode has been activated, the run-on
function is not available.
■ The fan flaps must remain closed while the run-on
function is active.
1. Select the fan setting.
2. Press the x button.
The LED û beside the x symbol will light up. The
fan will continue to run at this setting for 15 minutes
and then switch off automatically once this time has
elapsed.
Switching off
Press the # or x button.
This will deactivate the run-on function immediately.
Cooking with gas
:Warning – Risk of fire!
Fatty deposits in the grease filter may catch fire. If the
appliance is to be operated next to a gas-fired
appliance, a gas deflector must always be fitted before
you begin cooking.
Note: The gas deflector reduces deflection/disruption
of the gas flames from the burners on the cooktop and
prevents them from being blown out by draughts.
:Warning – Risk of burns!
The appliance will become hot during operation.Allow it
to cool down before touching the fan flaps, gas
deflector and other components.
Note: When the gas deflector is fitted, select intensive
mode or setting 3. This improves the extraction
performance of the worktop-mounted ventilation
system.
Note: When using pans for cooking, use the
appropriate pan lid. If necessary, place the lid on the
pan at a slight angle, with the gap facing the worktop-
mounted ventilation system. This improves the
extraction behaviour of the table ventilation.
To Next Page
Loading...
