en Installation
14
Preparing the appliance
A handle strip must be screwed to the filter pull-out. This
handle strip can be one that is provided with the
appliance, or one that is available as an accessory.
1. Use the screws provided to secure the handle strip
to the filter pull-out.
2. Connect the power cord provided to the appliance.
¨
3. Use the strain relief to secure the power cord in
place.©
4. Screw the four angle brackets to the appliance.
Ensure that the screws are positioned correctly.ª
Screw in the screws until 8 mm of the threaded
section is still protruding. «
5Installation
Installation
Installation
1. Use the angle brackets to hang the appliance on the
screws and align it.
[
$
%
To Next Page
Loading...
