RB500 Installation Guide 5
ENG
General
The RB500 can be connected to the system
product Bewator 2010 Omnis. The RB500 can be
ordered in two different variants supporting two
different reading technologies:
• Cotag technology (both active & passive)
• EM4102 technology
Important!
For proper use, this card reader needs that the
Bewator 2010 Omnis reader-node E2V has a
rmware version 4.012, or higher.
About this document
This document only serves as a Installation Guide
when using the RB500 with the main factory set-
ting and only the “short commands”.
To Next Page
Loading...
