RUGGEDCOM RST2228
Installation Guide
Chapter 4
Communication Ports
Installing/Removing Modules 29
7. Connect power to the device.
Installing a Module
To install a media module, do the following:
1. Make sure power to the device has been disconnected and wait approximately two minutes for any remaining
energy to dissipate.
2. [Optional] If the device is installed in a rack, remove it from the rack.
3. Remove the current module from the slot.
4. Insert the new module into the slot.
Figure26:Installing a Module
5. Tighten the screw(s) to secure the module.
6. [Optional] If necessary, install the device in the rack.
7. Connect power to the device.
To Next Page
Loading...
