2
Housing and cover: Permanent mold alloy 356 aluminum castings.
Precision CNC machining of all gear, shaft and motor surfaces.
Gear Train: 240 to 1 Reduction.
Bearings: Maintenance free sealed – both main and gear shaft.
Motor: 12 VDC, 4 pole compound series/permanent magnet.
Brake: Hold up, hold down =165ma @ 12VDC
Operating Voltage: 11 – 16 VDC.
Operating Current: Up = 6 – 15 A @ 12 VDC, Down = 6 – 15 A @ 12 VDC.
Circuit Breaker 7 Amp Auto-reset.
STANDARD FEATURES
Makeup of the S-40EXIT Gate Mechanism – Internal:
• Relay panel assembly complete with down rate resistors and over-speed control.
• Auto-reset circuit breaker motor protection.
• Standard Gate Control Relays.
• Adjustable snap action contact actuating cam for power up and power down (posi-
tions 7 & 8).
• Adjustable contact and cam for flashing light control (position 9).
• Adjustable contact and cam for bell control (position 10).
• Adjustable horizontal snub contact and cam (position 11).
Note: Contact cams are factory set as shown on wiring diagram, page 3.
• Adjustable snub resistors to set up time and down time (.80 ohm max).
• 115 VAC Defroster located under motor end and wired to terminal block position 1
with insulated nuts.
• Mechanism serial number located on motor housing label.
• Maintenance switch assembly with stop bracket – see page 13.
Makeup of the S-40EXIT Gate Mechanism – External:
• Lifting eyebolt.
• Shaft ends with 1”-8 UNC nuts, lock washers and hub keys.
• Mounting bolts and saddles for 5” pipe mounting.
• Mechanism support clamp for 5” pipe mounting.
• 2” x 42” long liquid tight conduit with one straight and one 45 degree connector.
• Mechanism serial number stamped on top outside of cabinet.
OPTIONS
• Additional contact and cam.
• Special contact cam settings.
• Special defroster - 230 VAC, 12 or 24 VDC.
SPECIFICATIONS
To Next Page