Siemens SCALANCE W788-2 M12 - Address Assignment with STEP 7

IP addresses
5.2 IPv4 address
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
82 Configuration Manual, 08/2018, C79000-G8976-C267-13
5.2.5
Address assignment with STEP 7
In STEP 7, you can configure the topology, the device name and the IP address; in other
words, an IP address is specified for the MAC address of the device. If you connect the
unconfigured device to the controller, the controller assigns the configured device name and
the IP address to the device automatically.
STEP 7 V5.x and earlier
For further information on the assignment of the IP address using STEP 7 V5.x and earlier,
refer to the documentation "Configuring Hardware and Communication Connections STEP
7", in the section "Steps for Configuring a PROFINET IO System".
STEP 7 as of V13
For further information on assigning the IP address using STEP 7 as of V13, refer to the
online help "Information system", section "Addressing PROFINET devices".