Siemens SIMATIC RF188C - Page 95

Configuring with the WBM
7.3 The menu items of the WBM
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 04/2020, C79000-G8976-C512-03
95
Displayed parameters
Description
Transponder type Set transponder type profile
The following values are possible:
Value Meaning
00
RF300 (RF3xxT)
01
ISO 15693 general
03
MDS D3xx, Infineon
04
MDS D4xx, Fujitsu - 2 KB
05
MDS D1xx, NXP
06
MDS D2xx, TI
07
MDS D261, ISTM
08
MDS D5xx, Fujitsu - 8 KB
10
RF300 (RF3xxT)
20
ISO 14443 (MOBY E, E6xx)
31
General Mode
40
P2P master
41 P2P master & combined mode with ISO transponder (MDS
Dxxx)
50
P2P master & combined mode with RF300 transponder
4F
P2P slave
Antenna status
Status of the antenna
Presence check Set presence check profile
Table 7- 20 Displayed parameters of the "Transponder status" area
Displayed parameters
Description
UID
Unique identifier of the transponder
Transponder type Transponder type (vendor, identification)
Version
Version of the transponder chip
Lock status of the OTP
area
Disabled blocks of the OTP area on the chip
Size of the user
memory
Memory size of the user memory in bytes
Size of a memory block
Size of the memory blocks of the transponder chip
Number of memory
blocks
Number of memory blocks of the transponder chip
Measured value power
flux density
Radiant power that arrives at the transponder.
The lower the value, the more power the transponder receives.
Passive error counter
Number of passive errors which occurred
Active error counter Number of errors which occurred
Sum of the signature and CRC errors
Presence counter
Time in [ms] that the transponder spent in the antenna field.