Siemens Simodrive 611 User Manual

Overview of Alarms 11/2006
NCK alarms
2-56
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
4290 Sign of life monitoring: local P-bus not alive
Definitions: The COM computer must alter the sign-of-life on the local P-bus in each SERVO cycle. Monitoring for
alteration takes place in the IPO cycle. If the sign of life has not altered, this alarm is triggered.
Reaction: NC not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Check hardware.
Program
Continuation:
Switch control OFF - ON.
4291 Failure of module in local P-bus slot %1, error codes %2 %3 %4
Parameters: %1 = Slot number
%2 = Error code
%3 = Error code
%4 = Error code
Definitions: The module on the specified slot has signaled a diagnostics alarm. The error code reported
corresponds to the AS300 documentation.
Reaction: NC not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Check hardware.
Program
Continuation:
Switch control OFF - ON.
4300 Declaration in MD %1 is not allowed for axis %2.
Parameters: %1 = String: MD identifier
%2 = Axis name, spindle number
Definitions: The axis cannot be operated as competing positioning axes,
for example because the axis is the slave axis within a closed gantry group or a gantry group to be
closed.
Reaction: Alarm display.
Remedy: Reset MD 30450 IS_CONCURRENT_POS_AX for the axis concerned.
Program
Continuation:
Clear alarm with the RESET key. Restart part program
4310 Declaration in MD %1 index %2 is not allowed.
Parameters: %1 = String: MD identifier
%2 = Index: MD array
Definitions: The machine data values must be written in the array in ascending order.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Correct the MD.
Program
Continuation:
Clear alarm with the RESET key in all channels of this mode group. Restart part program.

Siemens Simodrive 611 Specifications

General

Brand	Siemens
Model	Simodrive 611
Category	Media Converter
Language	English