11/2006 List of Action Numbers
3-839
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), Edition 11/2006
No. 40
No. 40
No. 41
No. 42
No. 43
No. 44
Explanation Start preprocessing (NC block: Stopre)
Cause -
Remedy -
Explanation Stop processing at block end (NC block: M00/M01).
Cause -
Remedy -
Explanation Stop processing at block end (NC block: M00/M01).
Cause -
Remedy -
Explanation Stop processing at block end (alarm, VDI signal: NC Stop at block limit).
Cause -
Remedy -
Explanation Stop at end of ASUB, if start was performed from "stopped"
Cause -
Remedy -
Explanation Activate program (PI command)
Cause -
Remedy -
To Next Page
Loading...
