To Next PageTo Next Page
Need help?Do you have a question about the Siemens Simodrive 611 and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | Simodrive 611 |
| Category | Media Converter |
| Language | English |
The following alarms are system errors... If such a system error occurs, please contact the hotline...
NCK alarms are sorted by ascending alarm number in each section. There are gaps in the sequence.
HMI alarms are sorted by ascending alarm number in each section. There are gaps in the sequence.
SIMODRIVE alarms are sorted by ascending alarm number in each section. There are gaps in the sequence.
PLC alarms are sorted by ascending alarm number in each section. There are gaps in the sequence.
Run Init phase (tasks are initialized after power on).
Perform reset (VDI signal: Reset, mode group reset or after power on).
Activate Reset Init blocks (VDI signal: Reset).
Perform reset, end of program has been detected (NC block with M30).
Change the mode to the MDI or AUTOMATIC program operating mode (VDI signal: Mode group).
Automatic change from an internal mode to the mode set externally (with TEACH_IN).
Change the mode to a manual mode (VDI signal (mode group): JOG, TEACH_IN, REF).
Activate test run (VDI signal: Rapid traverse override).
Deactivate test run (VDI signal: Rapid traverse override).
Start program processing (VDI signal: NC Start).
Start continuation of interpreter processing (internal preprocessing stop).
Start continuation of the selected process (JOG, reference point or digitizing).
Error in P:-RAM. Incorrect address. Detected written bitmap read error during power-up.
Error in X: or Y:-RAM. Incorrect address. Detected written bitmap read error during power-up.
Computing time overrun. Drive processor computing time insufficient for selected functions.
Servo sign-of-life monitoring not updated. Sign-of-life of the servo is monitored.
Error in state switch cabinet. Cause is probably a hardware error on the control module.
Background loop exited. Cause is probably a hardware error on the control module.
Synchronization failed. Illegal state read by hardware during cycle synchronization.
Stack overrun. Limits of internal processor or software stack violated.
NMI due to watchdog. Watchdog on control module timed out.
NMI due to clock cycle failure. NC basic cycle failed.
Clock cycle came too early. NC basic cycle pulse does not match clock timing.
Illegal Opcode, Trace, SWI, NMI (DSP). Processor detected illegal command in program memory.
Error in checksum test. Difference detected between setpoint and actual checksums.
SSI interrupt. Illegal processor interrupt occurred.
SCI interrupt. Illegal processor interrupt occurred.
Block preparation error, rectifiable by program modification. Reorganization after modification.
Block preparation error, rectifiable by program modification.
Program execution aborted after prepared blocks (interpolator buffer) are processed.
Questions? Contact Hotline: Europe and Africa time zone: A&D Technical Support.
Alarm displayed when machine data ENABLE_ALARM_MASK bit 0 is set.
Alarm displayed when machine data ENABLE_ALARM_MASK bit 1 is set.
Ready canceled in all mode groups. NCK REACTIONVIEW|NOREADY applied.
Alarm reactions buffered channel-specifically and not active.
The DELAY_ALARM_REACTION state is canceled.
Lists common abbreviations used in the document.
