To Next PageTo Next Page
Need help?Do you have a question about the Siemens SIMOTICS 1LA and is the answer not in the manual?
General| Product brand name | SIEMENS |
|---|---|
| Number of poles | 2, 4, 6, 8 |
| Degree of protection | IP55, IP56, IP65 |
| Insulation class | F |
| Product designation | SIMOTICS |
| Standards | IEC |
Outlines the five essential safety rules for working with electrical machines.
Specifies the qualifications and training required for personnel working on the machine.
Safety guidance for lifting eyes, suspended transport, and storage time.
Safety precautions and checklist before starting installation and machine startup.
Procedures for aligning, fastening, and flatness tolerances of machine components.
Safety information before connecting the machine and regarding line supply with non-grounded neutral.
Safety warnings regarding dangerous voltage when working with terminal boxes.
Warning about loosening safety screws and their importance for grounding.
Consequences of not following procedures when handling the terminal box.
Precautions to prevent dirt or moisture ingress into the terminal base.
Table providing tightening torques for various cable gland sizes and types.
Warning about hazardous voltages and precautions for laying connection cables.
Caution regarding converter operation with supply voltages and insulation systems.
Requirement to use shielded cables when connecting to frequency converters.
Procedure for checking insulation resistance before start-up and after storage.
Warnings on neutral point supply, cover removal, hot surfaces, and bearing load.
Safety instructions before starting maintenance work, including disconnection and PPE.
Instructions and safety guidelines for performing repairs on the gear unit.
Safety precautions for servicing gear units in potentially explosive atmospheres.
Steps for preparing and moving packages, including equipment capacity and load stability.
Procedures for safely moving the gear unit, including attachment points and load stability checks.
General instructions for planning and executing gear unit installation safely.
Instructions for machining and installing flanged gear units, including tolerances.
Checklist for final inspections before starting the gear unit, covering compliance and setup.
Identifying the danger zone around the gear unit's shaft and the need for protection.
Key maintenance actions like applying sealant, cooling before servicing, and final checks.
