1.3 - GLOSSARY AND
TERMINOLOGY
Same of the frequently occurring terms used in this manual are described below to unequivocally define their
meaning.
Routine maintenance
The set
of
operations required to preserve the functionality and efficiency of the gear unit. These operations
are usually scheduled by the Manufacturer, who defines the qualifications and tasks involved.
Reactive maintenance
The set
of
operations required to preserve the functionality and efficiency of the gear unit. These operations
are not scheduled by the Manufacturer and must be carried out by
an
expert maintenance technician.
Expert maintenance technician
An
authorised technician with the qualifications, skills and mechanical and electrical training required to do
repairs and non-routine maintenance work
on
the gear unit.
Overhaul
An
overhaul consists
in
the replacement
of
bearings and other mechanical components which have worn to
such an extent as to compromise the operation
of
the gear unit.
An
overhaul also includes verification
of
the
condition
of
all gear unit components (keys, seals, gaskets, vents, etc).
lf
any such components are dama-
ged they must be replaced and the reason for the damage identified.
1.4 - REQUESTING TECHNICAL ASSISTANCE
For any technical service needs, contact the Manufacturer's sales network quoting the information indicated
on
the unit's nameplate, the approximate hours
of
service and the type
of
defect.
1.5 - MANUFACTURER'S LIABILITY
The Manufacturer declines all liability in the event of:
• use of the gear unit
in
contravention
of
local safety at work legislation
• incorrect installation, disregard or incorrect application
of
the instructions provided
in
this manual
• incorrect
or
defective electrical/hydraulic power supply (gearmotors)
• modifications
or
tampering
• work done
on
the unit by unqualified
or
unsuitable persons.
The safety
of
the gear unit also depends on scrupulous observance
of
the instructions given in this manual,
and
in
particular:
• always operate the unit within its operating limits
• diligently observe the routine maintenance schedule
• only allow trained operators to inspect and service the unit
• only use original spare parts
• the configurations given
in
the gear unit catalogue are the only anes permitted
• do not attempt to use the unit
in
any other way
• the instructions given
in
this manual do not substitute but rather supplement the provisions
of
esta-
blished safety legislation.
1.6 - CONSIGNMENT CONDITIONS
Gear units are supplied by BONFIGLIOLI TRASMITAL in the following conditions:
4
• Configured for installation
in
the mounting position specified
in
the purehase arder.
• Not charged with lubricant and with internal components protected by a film
of
oil compatible with the
recommended lubricant.
• All surfaces and mating parts are treated with rustproofing produets.
• Mating surfaces are not painted while the unit's exterior is treated with a coat
of
grey water-based
rustproofing primer (RAL 7042/C441
).
Application
of
a top coat is the responsibility
of
the Client.
• Tested to factory standards.
• Packaged suitably for the final destination.
@ Bonfiglioli
Trasmitol
To Next Page
Loading...
