Ambient conditions
• Ambient temperature: min. - 20°C; max. + 40°C.
• Do not use the gear unit, if not explicitly intended for the purpose,
in
a potentially explosive atmosphere or
where the use of explosion-proof equipment is specified.
The nameplate specifications regarding the maximum surface temperature, refer to readings ta-
ken in normal ambient and installation conditions.
Even minimal variations to said conditions (e.g. smaller mounting cabinet) may have a significant
effect on the unit's heat output.
• Lighting
/.\.
lf
the unit is to be serviced
in
a poorly lit area, use additional lamps and ensure that the work is done
~
in
compliance with the safety requirements of established legislation.
3.0 - SAFE
TY
INFORMATION
3.1
- SAFETY STANDARDS
• Carefully read the instructions given
in
this manual and those posted directly on the gear unit, especially
those regarding safety.
• Persons charged with working
on
the gear unit at any time in its service life must be trained specifically for
the purpose with special abilities and experience
in
the area
as
well as being equipped with the appropria-
te tools and individual safety equipment (as per Legislative Decree 626/94). Failure to meet these require-
ments constitutes
arisk
to personal health and safety.
• The gear unit must only be used for the applications permitted by the Manufacturer. lmproper use can re-
sult
in
risks to personal health and safety and economic damages.
The
applications
permitted
by
the
Manufacturer
are
the
industrial
applications for
which
the
gear
units
have
been
designed.
• Keep the gear unit at its maximum efficiency by foliowing the routine maintenance schedule. Good mainte-
nance ensures the unit's maximum performance, extended service life and continued compliance with
sa
-
fety regulations.
• When working on the unit
in
areas which are difficult to access or hazardous, ensure that adequate safety
precautions have been taken for the operator and others
in
compliance with established legislation
on
he-
alth and safety at work.
• All maintenance, inspection and repairs must only be carried out by
an
expert maintenance technician fully
familiar with the attendant hazards. It is therefore essential to implement operating procedures that
ad
-
dress potential hazards and their prevention for the entire machina. The expert maintenance technician
must always work with caution
in
observance of applicable safety standards.
• During operation wear only the apparel and safety equipment indicated
in
the User lnstructions provided
by the Manufacturer or stipulated by legislation
on
safety at work.
• Replace worn components with original spare parts. Use the lubricants (oil and grease) recommended by
the Manufacturer.
• Do not dump polluting materials into the environment. Dispose of all such materials as stipulated by appli-
cable legislation.
• After replacing lubricants clean the gear unit's surfaces and the walk-
on
surfaces around the work area.
6
@
Bonfiglioli
Ttasmitol
To Next Page
Loading...
