EasyManua.ls Logo

Siemens SIMOTICS XP Series - O-Ring Seal

Siemens SIMOTICS XP Series
170 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance
9.3 Corrective maintenance
1MB..1/2/3/4 - shaft heights 63 ... 355
130 Operating Instructions, 06/2020, A5E44455710A
9.3.13 O-ring seal
If O-ring seals are present, you should check that they are in perfect condition and that the
O-ring seals are properly seated in the grooves between the components. Replace damaged
O-ring seals.
O-ring seals can be present on the following components, for instance:
● Adapters, tapers
● Entries, glands
● Bearing seals
● End shield seals
● Terminal box sealing
● etc.

Table of Contents