Intrusion Control Enabled
Intrusion Control has been enabled at the
reader.
A duress alarm has been entered at an
access point.
A cardholder has failed to use their card
when leaving an area with soft anti-passback
and has tried to re-enter the same area. The
cardholder will be allowed access.
A cardholder has failed to use their card
when leaving an area with hard anti-
passback and has tried to re-enter the same
area. The cardholder will be denied access.
A card read at a disabled
readhead
A card was read at a disabled readhead.
(Disabled readhead – refers to a card reader
that has been sent a manual Disable
command).
A card, from a group (of cards) that has been
disabled, was used at a reader or is invalid
for the reader where it was used.
A void card was read at an access point.
An invalid facility card was
read
An invalid Facility Code on a card was read
at an access point. (Each site has a site-
specific Facility Code).
The maximum number of cards supported by
the hardware (processor) has been reached.
An invalid PIN (Personal Identification
Number) was entered at an access point.
An invalid Daily Code was entered at a
keypad that requires a Daily Code to be
entered.
The elevator has been placed on
independent service. (The elevator operates
independ-ently of all other elevators, usually
controlled from inside the elevator itself).
Typically initiated when being repaired.
The emergency or alarm button within the
elevator has been activated.
The tamper input on a reader interface
module is active.
A reader has gone offline.
Access not granted on
reader
Access was denied at an access point.
The door latch has been unsecured.
Hard Anti-Pass back Error
A cardholder has failed to use their card
when leaving an area with soft anti-passback
and has tried to re-enter the same area. The
cardholder will be allowed access.