Siemens SiPass integrated

Host event tasks
Targets / Commands
7
A6V11144326
35 | 66
7.2 Targets / Commands
Target
Command
Description
ACC Trigger
Set Trigger
An ACC Trigger allows you to trigger a Controller
event task from a software event, like a Host
event task.
This Command activates the trigger selected.
Any Controller Event tasks of type “Host Control”
will be listed in the Location drop-down menu.
Clear Trigger
This Command clears the trigger selected, if it is
currently activated.
Access Point
Allow Access
Allow access as if a valid card has been
presented at the reader. The door lock will re-
lock after the defined Latch time.
Lock Door
Locks the door temporarily until the next change
in Time Schedule.
Unlock Door
Unlocks the door temporarily until the next
change in Time Schedule.
Set Mode “Card Only”
Enables Card Only operation at an access point.
Refer to Operational modes page 22 for more
information.
Set Mode “Card and
PIN”
Enables Card and PIN operation at an access
point. Refer to Operational modes page 22 for
more information.
Set Mode “H. V. Card
Only”
Enables Host Verification Card Only operation at
an access point. Refer to Operational modes
page 22 for more information.
Set Mode “H. V. Card
and PIN”
Enables Host Verification Card and PIN
operation at an access point. Refer to
Operational modes page 22 for more
information.
Set Mode “V. O. Card
Only”
Enables View Only Card Only operation at an
access point. Refer to Operational modes page
22 for more information.
Set Mode “V. O. Card
and PIN”
Enables View Only Card and PIN operation at an
access point. Refer to Operational modes page
22 for more information.
Set Mode “D. R. Card
Only”
Enables Delayed Reporting Card Only operation
at an access point. Refer to Operational modes
page 22 for more information.
Set Mode “D. R. Card
and PIN”
Enables Delayed Reporting Card and PIN
operation at an access point. Refer to
Operational modes page 22 for more
information.
Set Mode “Disabled”
Disables an access point. Refer to Operational
modes page 22 for more information.
Restore Access Mode
Restores the previous access mode at an access
point. Refer to Operational modes page 22 for
more information.
Reset Reader Tamper
Resets the reader tamper. Only applies to the
Siemens reader range.
Block Door
Blocks the door and prevents cards from being
used to gain access at the door using the
selected reader.