Defines the Input point as a fire stair door
contact sensor.
PIR mode defines the input point as a PIR
detector.
Only normal states are reported to the system
Only alarm states are reported to the system
Disables alarm reporting from the input point to
the server. This will prevent alarms from
occurring and appearing in the Audit Trail, but
Event Tasks will still be triggered.
Intrusion Area Entry/Exit
Defines the input type as normal except if the
cardholder has isolation privileges, they can
override a point (if the point is not sealed).
Intrusion Area No Seal
Check
The input seals are not checked when intrusion
area is armed. Defines the input type as normal.
Intrusion Area
Instantaneous
Defines the input type as normal except that
when the area is secured, there are no entry or
exit delay times.
Allows secured areas to be accessed in order
for an alarm unit to be switched off.
Allows access to the area for the time
configured in the Delay field.
Allows access by unlocking the point, followed
by a quick re-lock.
Toggles the access point between the Lock and
Unlock state, each time a card is badged at the
access point.
To Next Page
Loading...
