Siemens SiPass integrated

Controller Event Tasks
Commands
8
A6V11144326
51 | 66
Type
Command
Description
Set mode “Authorization
– Card Only”
Set mode “Authorization
– Card + PIN”
Anti-Passback
Area
Reset Count
Resets the current count for the anti-
passback area to zero.
Override Mode
Override the selected area with a specific
mode.
Restore Mode
Restores the configured Anti-Passback
mode.
Controller
Turn Siren On
If a siren has been connected to the ACC,
it will be activated.
Turn Siren Off
If a siren has been connected to the ACC
and is currently active, it will be de-
activated.
Device
Device Reset
A device has been reset.
Report all inputs
Reports all inputs on a device.
Card Format Override
This Controller Event Task is specifically
for Legacy Asco RIM devices. For further
details regarding this event task, please
contact the Technical Support Team.
Door Interlocking
Disable Door Interlocking
Disable Door Interlocking.
Restore Door
Interlocking
Restore Door Interlocking.
Floor
Bank Floor Secure
Secures the specified elevator floor (for all
elevators within the same bank).
Bank Floor Unsecure
Unsecures the specified elevator floor (for
all elevators within the same bank).
Bank Floor Enable
Enables the specified elevator floor (for all
elevators within the same bank).
Bank Floor Disable
Disables the specified elevator floor (for all
elevators within the same bank).
Return to Time Schedule
Returns the programmed access control for
the specified floor.
Cancel Permanent
Action
Any current Permanent Command or Event
Task, or Access/Internal Action operating
on the floor will be cancelled. The next
Control State in the Control State Queue
will take effect.
Input Point
Disable
Disables the selected input point.
Enable
Enables the selected input point.
Return to Time Schedule
Control
The output will return to normal Time
Schedule control.
Cancel Permanent
Action
Any current Permanent Command or Event
Task, or Access/Internal Action operating
on the target will be cancelled. The next
Control State in the Control State Queue
will take effect.