Siemens SITRANS LUT430 - Flow Calculation Parameters

A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 167
mmmmm
Parameters
2.8.7.1. Enable
Enables/disables High Temperature Alarm.
2.8.7.2. High Temperature Value ON
Sets the temperature value (defined in ° C) at which the High Temperature
Alarm will activate.
2.8.7.3. High Temperature Value OFF
Sets the material level (defined in ° C) at which the High Temperature Alarm
will de-activate.
2.8.7.4. Assigned Relay
Determines which relay (if any) will be activated when the High
Temperature Alarm activates.
2.8.7.5. Alarm State
Read only. Used to view the current state of the High Temperature Alarm.
2.8.8. Fail-safe Fault Alarm
Reported when fault that has caused a fail-safe condition is present.
2.8.8.1. Enable
Enables/disables Fail-safe Alarm.
Options
ENABLED
* DISABLED
Values
Range: -273.0 to +273.0 °C (-459.0 to +523.0 °F)
Default: 100.0 °C
Values
Range: -273.0 to +273.0 °C (-459.0 to +523.0 °F)
Default: 100.0 °C
Options
*
NO RELAY
RELAY 1
RELAY 2
RELAY 3
Options
ACTIVE
INACTIVE
Options
ENABLED
* DISABLED