To Next PageTo Next Page
Need help?Do you have a question about the Siemens SITOP UPS1600 under STEP 7 V12 and is the answer not in the manual?
General| Product type designation | SITOP UPS1600 |
|---|---|
| Operating voltage | 24 V DC |
| Output voltage | 24 V DC |
| Output current | 40 A |
| Protection class | IP20 |
| Integration via | PROFINET |
| Communication protocol | PROFINET |
| Diagnostics | Yes |
| Battery type | Lead-acid |
Explains the goal of the guide and the tasks covered.
Provides contact information for technical assistance and relevant online resources.
Lists other manuals and resources for further detailed information.
Provides an overview of the SITOP UPS Management application and its supported devices.
Introduces the need for an IP address and the Primary Setup Tool for configuration.
Lists the requirements needed before starting the IP address assignment process.
Details the necessary prerequisites for installing and configuring the UPS1600 in STEP 7 V12.
Guides on how to add the UPS1600 device into a STEP 7 V12 project.
Details the steps for adding the UPS1600 to the project using the hardware catalog.
Explains how to configure the UPS for buffering the S7 IO controller during power outages.
Describes using a user program to shut down the UPS during power failures.
