Siemens SITOP UPS1600 under STEP 7 V12 - Assigning the IP address; General information; Preconditions

SITOP UPS1600 under STEP 7 V12
Getting Started,
11
Assigning the IP address
4
Just like all devices connected to PROFINET, SITOP UPS1600 requires an IP address. This
is defined by the person responsible for the system. In this Getting Started, the configuration
of the SITOP UPS1600 interface is described using the Primary Setup Tool.
General information
The Primary Setup Tool is a Siemens product that is free of charge and which is used to
identify and configure network-conform devices. You can download the Primary Setup Tool
under (http://support.automation.siemens.com/WW/view/en/19440762
).
Note
Additional information
Additional information is contained in the Primary Setup Tool manual. This manual and
further links can be found under
(
http://support.automation.siemens.com/WW/view/en/19440762).
Preconditions
● The SITOP UPS1600 is connected with the client (PG/PC) via the Ethernet interface.
● The Primary Setup Tool is installed on the client.