Fault, what to do? en
29
A different error code is
indicated on the digital
display.
(“:‹‚ to “:„‹)
A technical fault has probably
occurred.
Switch off appliances with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Display flashes. Door not closed properly. Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.
Refill indicator for salt @
and/or rinse-aid H is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with special salt.
Sensor does not detect salt
tablets.
Use different special salt.
Refill indicator for salt @
and/or rinse-aid H is not
lit.
Refill indicator switched off. Activation/deactivation (see chapter Water
softening system/Special salt or Rinse aid).
There is still enough special salt/
rinse aid available.
Check refill indicator, levels.
Water is left in the
appliance at the end of the
programme.
Filter system or area under the
filters 1Z is blocked.
Clean filters and area underneath (see
“Waste water pump”).
Program has not ended yet. Wait until programme ends or reset (see
“Terminating the programme”).
Fault Cause Remedial action
To Next Page
Loading...
Need help?
General
