Need help?Do you have a question about the Siemens SP Series and is the answer not in the manual?
General| Type | Built-in |
|---|---|
| Place Settings | 12 |
| Number of Programs | 5 |
| Special Features | Delay start |
| Water Consumption | 9.5 liters per cycle |
| Weight | 45 kg |
Lists and describes the functions of the control panel buttons and indicators.
Amount of salt dispensed is set in 4 stages based on water hardness.
Refill with special salt immediately before switching on to avoid corrosion.
Refill rinse aid when indicator is lit for stain-free utensils and clear glasses.
Adjust rinse aid dispensing in 4 stages based on water hardness.
Place utensils securely, openings down, and do not obstruct spray arms.
Instructions for filling the detergent dispenser with powder, liquid, or tablets.
Details on 3-in-1, 4-in-1 detergents and their limitations regarding water hardness.
Function reduces running time by 20-50% but increases water/energy consumption.
Ideal for mixed loads with heavily soiled pots/pans in lower basket.
Delay the start of the programme by 3, 6, or 9 hours.
Check refill indicators and refill salt and/or rinse aid if required.
How to check, remove, and clean the filter system to prevent pump blockages.
How to check and clean spray arm nozzles to prevent blockages.
Instructions for clearing blockages in the waste water pump.
A table listing faults, their causes, and recommended remedial actions.
Details on weight, voltage, power, fuse, water pressure, and capacity.
Required installation dimensions and leveling the appliance.
Connecting the appliance to the power supply with safety precautions.
To Next Page
