Siemens SR93EX28ME User Manual

Troubleshooting en
45
Error code / Fault display / Signal
Fault Cause troubleshooting
E:21-60 will light up altern-
ately.
Appliance has detected cal-
cified heating element.
1. Descale the appliance.
2. Operate the appliance with the Wa-
ter softening system.
E:30-00 will light up altern-
ately.
Water protection system is
activated.
1. Turn off the water tap.
2. Call "Customer Service"
→Page57.
E:31-00 will light up altern-
ately.
Water protection system is
activated.
1. Turn off the water tap.
2. Call "Customer Service"
→Page57.
E:34-00 will light up altern-
ately.
Water is continuously run-
ning into the appliance.
1. Turn off the water tap.
2. Call "Customer Service"
→Page57.
E:32-00 will light up altern-
ately or indicator for water
supply lights up.
Supply hose is kinked.
▶
Install the supply hose without
kinks.
Water tap is turned off.
▶
Turn on the water tap.
Water tap is jammed or
furred up.
▶
Turn on the water tap.
The flow rate must be at least 10 l/
min when the water supply is open.
The filters in the water con-
nection of the supply or
AquaStop hose are blocked.
1. Switch off the appliance.
2. Pull out the mains plug.
3. Turn off the water tap.
4. Unscrew the water connection.
5. Remove the filter from the supply
hose
6. Clean the filter.
7. Re-insert the filter in the supply
hose.
8. Screw the water connection back
on.

Siemens SR93EX28ME Specifications

General

Brand	Siemens
Model	SR93EX28ME
Category	Dishwasher
Language	English