EasyManua.ls Logo

Siemens TE 803 - Cleaning the milk system

Siemens TE 803
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
en
K
Do not put the following items in the
dishwasher: Panel of drip tray 23a,
powder compartment 18, brewing unit
20, water tank 11, aroma cover 16 and
stainless steel milk container.
J
The following parts may be cleaned
in the dishwasher: Drip tray 23, grate
23b, coffee grounds container 23c,
measuring spoon 14 and the individual
parts of the milk container cover.
Remove powder compartment 18 and
rinse under running water.
Wipe out the inside of the tray holders.
Important: Drip tray 23 and coffee
grounds container 23c should be emptied
and cleaned daily to prevent mould from
developing.
Note: If the appliance is cold when
switched on, or if it is switched off after
dispensing coffee, it rinses automatically. In
other words, the system cleans itself.
Important: If the appliance has not been
used for a prolonged period of time (e. g.
after a vacation), clean the entire appliance
thoroughly, including the milk system 10
and brewing unit 20.
Cleaning the milk system
Important: The milk system 10 must be
cleaned immediately after use!
The milk system 10 can be pre-cleaned
automatically (see “Service programmes” or
cleaned manually.
Dismantling the milk system 10 for cleaning:
Pull the milk system 10 forward out of the
appliance.
Turn the upper part 10a in an anti-
clockwise direction and remove from the
lower part 10b.
Clean the individual parts with detergent
solution and a soft cloth.
Rinse all parts with clean water and dry.
Put all the parts back together. The milk
frother can then be clicked back into
place in the appliance.
Info: All parts of the milk frother 10 can also
be put in the dishwasher.

Table of Contents

Related product manuals