Why is my Siemens TE501 Coffee Maker water filter loose?
If the water filter does not stay in position, it is likely not fitted correctly. Firmly press the water filter straight down into the tank connection.
Why is Siemens TE501 Coffee Maker producing little milk froth?
If there is too little or no milk froth, it is likely that the milk frother (6) is soiled. Clean the milk frother (6).
Why is Siemens TE501 Coffee Maker not dispensing hot water?
If no hot water is dispensed, the milk frother (6) may be soiled. Clean the milk frother (6).
Why is Siemens TE501 Coffee Maker milk frother not assembled correctly?
To correctly assemble the milk frother (6), wet the milk frother parts and press together firmly.
Why is LED I lit on Siemens TE501?
If LED I lights up, the brewing unit (5) is missing or has not been detected. Switch off the appliance with the brewing unit (5) in place, wait three seconds and switch on the appliance again.
What to do if Siemens TE501 Coffee Maker drips after removing drip tray?
If water dripped onto the inner floor of the appliance when the drip tray (8) was removed, it is because the drip tray (8) was removed too soon. Wait a few seconds after the last drink was dispensed before removing the drip tray (8).
What to do if Siemens Coffee Maker coffee or milk froth quality varies?
If you notice that the coffee or milk froth quality varies widely, it is probably due to build-up of limescale in the appliance. Descale the appliance with two descaling tablets as described in the instructions.
Why is my Siemens TE501 Coffee Maker milk unsuitable for frothing?
If the milk is unsuitable for frothing, use milk with a fat content of at least 1.5%.
What to do if LED D lights up on Siemens TE501 Coffee Maker?
If LED D lights up, it indicates that the water tank has been incorrectly inserted or the new water filter has not been rinsed according to instructions. Ensure the water tank is inserted correctly or rinse the water filter according to instructions and then switch on.
How to reset default settings on Siemens TE501 Coffee Maker?
To reset the default settings on your Siemens Coffee Maker: * Switch off the appliance by pressing the power on/off button O / I (9). * Press and hold the service button (12) and the steam button (11), then press the power on/off button O / I (9) to switch on the appliance. * Finally, press the start button (10) to confirm. This will reset the default settings.
Details hazards related to electrical safety and precautions.
Warns about suffocation hazards, especially regarding packaging.
Describes how to switch the appliance on and off.
How to set and adjust the water hardness level for proper operation.
Detailed steps for cleaning the milk frother after each use.
General| Milk Frother | Yes |
|---|---|
| Dimensions | 59.4 x 38 x 51.8 cm |
| Weight | 10 kg |
| Pump Pressure | 15 bar |
| Coffee Strength Settings | Yes |
| Bean Container Capacity | 300 grams |
| Display | LCD |
| Color | Black |
To Next Page