Siemens TQ505DF Series - Page 67

Cleaning and servicing en
67
4. To start the programme, press ⁠.
a The display will guide you through
theprogramme.
5. Empty and insert the drip tray.
6. Remove and empty the milk con-
tainer.
7. Clean the milk container, milk tube
and suction pipe.
8. Fit the components and insert the
milk container.
9. If there is a water filter, remove it.
10.Press ⁠.
11.Empty the water tank.
12.Fill a container with 0.5l lukewarm
water.
13.Add a Siemens descaling tablet to
the water and stir until the tablet is
fully dissolved.
14.Pour the descaling solution into
the water tank up to the calc mark
and press ⁠.
15.Place the empty container under
the outlet system and press ⁠.
a The descaling programme will run
for approx.20minutes.
16.Rinse the water tank.
17.Press ⁠.
18.If there is a water filter, insert the
water filter.
→"Inserting and activating the wa-
ter filter", Page58
19.Press ⁠.
20.Fill the tank with fresh water up to
the "max" mark.
21.Press ⁠.
a The programme takes ap-
prox.1minute and rinses the ap-
pliance.
22.Empty and insert the drip tray.
23.Open the ground coffee compart-
ment.
24.Place one Siemens cleaning tablet
into the ground coffee compart-
ment.
25.Close the ground coffee compart-
ment and press ⁠.
26.Place a container with a capacity
of min. 0.5l under the outlet sys-
tem and press ⁠.
a The cleaning programme takes ap-
prox. 7minutes.
27.Empty and insert the drip tray.
28.Remove and empty the milk con-
tainer.
29.Clean the milk container, milk tube
and suction pipe.
30.Fit the components and insert the
milk container.
a The program has ended and the
appliance is ready for operation.