EasyManua.ls Logo

Siemens WG44G201IL - Starting the Programme; Soaking Laundry; Adding Laundry; Cancelling the Pro- Gramme

Siemens WG44G201IL
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en operation
30
13.8 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page28
Press ⁠Start/Reload.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the "Ready in" time.
a After the programme has ended,
the display shows: End.
13.9 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press ⁠Start/
Reload.
3. To resume the programme, after
the desired soaking time, press
⁠Start/Reload.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press ⁠Start/Reload.
The appliance pauses.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page21
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press ⁠Start/Reload.
13.11 Cancelling the pro-
gramme
1. Press ⁠Start/Reload.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
If the temperature is high, start
the ⁠Rinse programme.
If the water level is high, start
the ⁠Spin programme or select
a suitable programme for drain-
ing.
→"Programmes", Page24
3. Remove the laundry.
→"Unloading the laundry",
Page30
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→"Buttons", Page22
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1. Set the ⁠Spin programme or a
programme for draining the water.
→"Programmes", Page24
2. Press ⁠Start/Reload.
13.13 Unloading the laundry
1. Open the door.
2. Remove the laundry from the
drum.
13.14 Switching off the appli-
ance
1. Turn the programme selector to .

Table of Contents

Related product manuals