Siemens WG44G2AXES - Cancelling the Programme; Resuming the Programme When the Programme Status Is Rinse Hold; Unloading the Laundry; Switching off the Appli- Ance

en Childproof lock
32
2. Open the appliance door.
3. Add or remove laundry.
4. Close the appliance door.
5. Press inicio pausa + carga.
13.9 Cancelling the pro-
gramme
1. Press inicio pausa + carga.
2. Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the ⁠ programme.
– If the water level is high, start
the programme or select a
suitable programme for draining.
→"Programmes", Page25
3.
Remove the laundry →Page32.
13.10 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1. Set the programme or a pro-
gramme for draining the water.
→"Programmes", Page25
2. Press inicio pausa + carga.
13.11 Unloading the laundry
1. Open the appliance door.
2. Remove the laundry.
13.12 Switching off the appli-
ance
1. Turn the programme selector to .
2. Wipe the rubber gasket dry and re-
move any foreign objects.
3. Leave the appliance door and de-
tergent drawer open so that resid-
ual water can evaporate.
14 Childproof lock
Secure your appliance against being
operated unintentionally using the
controls.
14.1 Activating the childproof
lock
▶ Press and hold the two ⁠3 s but-
tons for approx. 3seconds.
a The display shows .
a The controls are locked.
a The childproof lock remains active
even after the appliance has been
switched off and in the event of a
power failure.
14.2 Deactivating the child-
proof lock
Requirement:To deactivate the
childproof lock, the appliance must
be switched on.
▶ Press and hold the two ⁠3 s but-
tons for approx. 3seconds.
a goes out in the display.