Siemens WG44G2AXES - Basic Dosage

en Intelligent dosing system
34
1. Pull out the detergent drawer.
2. Open the dispenser cover.
3. Pour liquid detergent and fabric
softener into the relevant dis-
pensers.
→"Detergent drawer", Page18
Do not exceed the marking for the
maximum filling level when filling.
4. Close the dispenser cover.
Note:To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
5. If required, add cleaning aids such
as stain remover, water softener or
bleach into the compartment for
manual dosing.
→"Adding detergent and care
product", Page31
6. Push in the detergent drawer.
7. Adjust the basic dosage
→Page34.
15.3 Basic dosage
The basic dosage depends on the
manufacturer's instructions for the de-
tergent, the water hardness and the
degree of soiling of the laundry.
Always set a basic dosage that cor-
responds to the dosage for a stand-
ard load of 4.5 kg.
Adjusting the basic dosage
1. Press and hold ⁠i-Dos for approx.
3 seconds.
a The display shows the basic
dosage set for .
2. To adjust the basic dosage for ,
press ⁠i-Dos.
3. To adjust the setting, press ⁠ter-
min..
4. To end the setting process, wait
briefly.