Siemens WG44G2MG0 - Before Using for the First Time; Starting an Empty Washing

Before using for the first time en
19
Before using for the first time
6 Before using for the
first time
Before using for the first time
Prepare the appliance for use.
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
1. Turn the programme selector to
Trommel Reinigen.
2. Close the door.
3. Pull out the detergent drawer.
4. Pour standard washing powder
into compartmentII.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
5. Push in the detergent drawer.
6. Press Start/Nachlegen (Start/Re-
load) to start the programme.
a The display shows the remaining
programme duration.
a After the programme has ended,
the display shows: "-0-".
7. Start the first wash cycle or set the
programme selector to to switch
off the appliance.
→"Basic operation", Page29