Siemens WG54G20XEP - Changing the Basic Set- Tings; Cleaning and Servicing; Tips on Appliance Care; Cleaning the Drum

en Cleaning and servicing
40
15.2 Changing the basic set-
tings
1. Set the programme selector to po-
sition 1.
2. Press and, at the same time,
turn the programme selector to po-
sition2.
a The display shows the current
value.
3. Set the programme selector to the
required position.
→"Overview of the basic settings",
Page39
4. To change the value, press
⁠termin..
5. To save the changes, switch off
the appliance.
Cleaning and servicing
16 Cleaning and servi-
cing
Cleaning and servicing
To keep your appliance working effi-
ciently for a long time, it is important
to clean and maintain it carefully.
16.1 Tips on appliance care
Wipe down the
housing and the
control panel
with nothing but
water and a
damp cloth.
This ensures the
parts of the appli-
ance will remain
clean and hy-
gienic.
Remove all de-
tergent residue,
spray residue or
other residues
immediately.
Fresh deposits
are easier to re-
move without
leaving any
residue.
Keep the appli-
ance door and
detergent drawer
open after use.
This allows the
residual water to
dry, reducing
odours in the ap-
pliance.
16.2 Cleaning the drum
CAUTION
Risk of injury!
Permanently washing at low temper-
atures and a lack of ventilation for
the appliance may damage the drum
and cause injury.
▶
Regularly run a programme for
cleaning the drum or wash at tem-
peratures of at least 60°C.
▶
Leave the appliance to dry after
every operation with the door
open, and leave the detergent
drawer to dry.
▶
Run the limp. tambor programme
without laundry and using all-pur-
pose washing powder.
16.3 Cleaning the detergent
drawer
1. Pull out the detergent drawer.