Siemens WG54G20XEP - Page 45

Cleaning and servicing en
45
Cleaning the filter on the tap
Note:Please read the information in
the sections on Safety →Page4 and
Preventing material damage
→Page10.
Requirement:The water inlet hose is
empty.
1. Remove the water inlet hose from
the tap.
2. Clean the filter with a small brush.
3. Connect the water inlet hose and
check for leaks.
Cleaning the filter on the
appliance
Note:Observe the information on
safety →Page4 and preventing ma-
terial damage →Page10.
Requirement:The water inlet hose is
empty.
→"Emptying the water inlet hose",
Page44
1. Disconnect the hose from the rear
of the appliance.
1
2