Siemens WG54G2F0GB - Page 45

Troubleshooting en
45
Fault Cause and troubleshooting
"E:30 / -10" and/or 2. To reset the error message, switch the appliance
off.
3. Switch the appliance back on.
4. If the error message is displayed again, call cus-
tomer service.
→"Customer Service", Page55
flashes. The automatic voltage control system detects an un-
authorised voltage drop.
▶ No remedial action possible.
Note:If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
lights up. The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page33
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page25
flashes. Door is not closed.
▶ Close the door.
Laundry is caught in the door.
▶ Remove any trapped laundry.
"E:30/-20" Detergent dosage is too high.
▶ If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
Additional water is added.
▶ Do not add any extra water to the appliance while it
is operating.
Solenoid valve defective.
▶ Call the after-sales service.
→"Customer Service", Page55