Siemens WG54G2F0GB - Page 46

en Troubleshooting
46
Fault Cause and troubleshooting
All other error codes. Malfunction
1. Switch the appliance off and then on again.
2. If the message appears again, disconnect the appli-
ance from the power supply for at least 30 seconds
by pulling out the plug or by switching off the relev-
ant circuit breaker in the fuse box.
a If the fault was a one-off, the message disappears.
3. If the message appears again, call the after-sales
service. Please specify the exact error message
when calling.
→"Customer Service", Page55
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶ Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶ Check the circuit breaker in the fuse box.
There has been a power cut.
▶ Check whether the lighting in your kitchen or other
appliances are working.
The programme does
not start.
You have not pressedStart / Reload.
▶ Press Start / Reload.
Door is not closed.
▶ Close the door.
Childproof lock is activated.
▶ Deactivate childproof lock.
→"Deactivating the childproof lock", Page34
Ready in is activated.
▶ Check whether Ready in is activated.
→"Buttons", Page23
Laundry is caught in the door.
▶ Remove any trapped laundry.
The detergent drawer has not been pushed in fully.
▶ Push in the detergent drawer until the symbol goes
out.
The pump for the intelligent dosing system is blocked.
1. Switch off the appliance.
2. Clean the pump unit.
→"Cleaning the detergent drawer", Page38
3. Switch the appliance on.