Siemens WG54G2ZXES - Starting the Programme; Adding Laundry; Cancelling the Pro- Gramme; Resuming the Programme When the Programme Status Is Rinse Hold

en operation
32
13.8 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page30
▶ Press inicio pausa+carga.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End".
13.9 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press inicio pausa+carga.
The appliance pauses.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page22
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press inicio pausa+carga.
13.10 Cancelling the pro-
gramme
1. Press inicio pausa+carga.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the programme.
– If the water level is high, start
the programme or select a
suitable programme for draining.
→"Programmes", Page25
3. Remove the laundry.
→"Unloading the laundry",
Page32
13.11 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1. Set the programme or a pro-
gramme for draining the water.
→"Programmes", Page25
2. Press inicio pausa+carga.
13.12 Unloading the laundry
1. Open the door.
2. Remove the laundry from the
drum.
13.13 Switching off the appli-
ance
1. Turn the programme selector to .
2. Turn off the tap.
3. Wipe the rubber gasket dry and re-
move any foreign objects.
4. Leave the appliance door and de-
tergent drawer open so that resid-
ual water can evaporate.