Siemens WG54G2ZXES - Changing the Basic Set- Tings; Programme Counter; Calling up the Programme Counter; Cleaning and Servicing

Programme counter en
35
15.2 Changing the basic set-
tings
1. Set the programme selector to po-
sition 1.
2. Press inicio pausa+cargaand, at
the same time, turn the pro-
gramme selector to position2.
a The display shows the current
value.
3. Set the programme selector to the
required position.
→"Overview of the basic settings",
Page34
4. To change the value, press ⁠ter-
min..
5. To save the changes, switch off
the appliance.
16 Programme counter
The program counter displays the
number of finished programmes.
16.1 Calling up the pro-
gramme counter
1. Set the programme to position1.
2. Press inicio pausa+carga and set
the programme to position 2 at the
same time.
3. Set the programme to position5.
17 Cleaning and servi-
cing
To keep your appliance working effi-
ciently for a long time, it is important
to clean and maintain it carefully.
17.1 Cleaning the drum
CAUTION
Risk of injury!
Permanently washing at low temper-
atures and a lack of ventilation for
the appliance may damage the drum
and cause injury.
▶ Regularly run a programme for
cleaning the drum or wash at tem-
peratures of at least 60°C.
▶ Leave the appliance to dry after
every operation with the door
open, and leave the detergent
drawer to dry.
▶ Run the programme limp. tambor
without laundry and using washing
powder that contains bleach.
17.2 Cleaning the detergent
drawer
1. Pull out the detergent drawer.
2. Press down on the insert and re-
move the detergent drawer.