Positioning and connecting en
37
■ No multiple plugs/couplings or
extension cables are used.
■ If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■ The mains plug can be accessed at
all times.
■ The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without any laundry.
Notes
■ The washing machine must be
correctly
installed and connected.
From ~ Page 32
■ Never use a damaged machine.
Inform your after-sales service.
1. Check the machine.
2. Remove the protective film from the
control panel.
3. Connect the mains plug.
4. Turn on the water tap.
5. Close the washing machine door (do
not load any laundry).
6. Select thei
Cottons programme
and set the temperature to
90 °C.
7. Open the detergent drawer.
8. Pour approx. 1 litre of water into
compartment
II.
9. Pour standard detergent into
compartment
II.
Note: To prevent foaming, only use
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
10.Close the detergent drawer.
11.Press
Start.
12.Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
To Next Page
Loading...
