Siemens WM14K2S8DN User Manual

en Operating the appliance
20
■ w flashes: The childproof lock is
active and the programme selector
was adjusted. To prevent the
programme from stopping, turn the
programme selector back to the
original programme. The symbol
lights up again.
Note: The childproof lock can remain
activated until you wish to start the next
programme, even after switching off the
machine.
You must then deactivate the childproof
lock before starting the programme and
activate it again as necessary once the
programme has started.
Adding laundry
After starting the programme, you can
add or remove laundry as required.
To do this, press the Start/Pause
button.
The "Start/Pause" indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
Note: Do not leave the washing
machine door open for too long when
adding laundry as water from the
laundry may leak out.
If, in the display panel:
■ Both the YES and v symbols light
up, it is possible to add laundry.
■ NO flashes, wait until the YES and v
symbols light up.
Do not open the washing machine
door until both the YES and v
symbols are lit.
■ NO lights up, it is not possible to add
laundry.
For safety reasons, the washing
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry.
To continue the programme, press
the Start/Pause button. The
programme continues automatically.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1. Press Start/Pause.
2. Select the other programme.
3. Press Start/Pause . The new
programme starts from the
beginning.
Cancel the programme
Programmes at high temperatures:
1. Press Start/Pause.
2. To cool the laundry: Select Rinse.
3. Press Start/Pause .
For programmes at low temperatures:
1. Press Start/Pause.
2. Select Spin or Empty.
3. Press Start/Pause.
Programme end during rinse
hold
– – – 0 appears on the display panel
and the Start/Pause button indicator
lamp flashes.
To end the programme, set the
programme selector to Spin/Empty or
select a spin speed. Then press the
Start/Pause button.
Programme end
End appears on the display panel and
the Start/Pause button indicator lamp is
off.
If the x symbol appears on the display
panel, the washing machine has
detected too much foam during the
wash programme and automatically

Siemens WM14K2S8DN Specifications

General

Brand	Siemens
Model	WM14K2S8DN
Category	Washer
Language	English